Description
LEYCO®-FR 100 solves all exterior cleaning problems for construction site vehicles — concrete pumps, cement mixers, trucks, loaders, equipment and machinery. It is also suitable for shipyards.
Technical Data
Density (20°C): ~ 1,08 kg/ l (1 l = 1,08kg)
pH: ~ 13
Instructions for Use
The best results with LEYCO®-FR 100 are achieved by spraying the product onto the surface to be cleaned. The product must be diluted with water beforehand — mixing ratio 1:3 to 1:20 (for difficult cases). A few minutes after applying the solution (approximately 3–5 minutes), wash the surface with a pressure washer. It can also be placed in the detergent compartment of pressure washers. The dosage in the pressure washer (depending on the difficulty and quantity of dirt) should be between 1:25 and 1:50 (0.25–0.2%). Do not apply the product to surfaces heated by the sun. Always apply from bottom to top to avoid runs and streaks. Apply carefully on painted surfaces and old red paint (test before use).
Precautions
The product is not affected by low temperatures. Water pollution category: WGK 2 = heavy pollutant (manufacturer’s assessment) / WGK 1 = light pollutant (manufacturer’s assessment). Easily dissolved in the drainage system when used at the prescribed concentration.
